effect of magnesia alumina spinel precursor sol on the

msg-pic Get Quick Quote

If you have any problems or questions about our products or need our support and assistance, please contact us and you will be replied within 24 hours. We promise we will never reveal your information to the third party. Thank you!

Ship Quickly Customized Solutions Free Installation

Relate Projects

  • magnesia form spinel solution with spinel similar crystal structure [3]. Ali Saberi et al. have studied the influence of heat treatment atmosphere in synthesis of nanosize spinel powder employing sol

    MORE
  • Magnesium aluminate (MA) spinel is synthesized by reaction sintering from alumina and magnesia. The effects of mechanical activation of Al2O3 on reaction sintering were investigated. Non-milled α Al2O3 and α Al2O3 2O3α

    MORE
  • The amorphous gamma phase of alumina was transformed completely into crystalline alpha phase, accompanied by a lower surface area of alumina at a higher concentration of urea. Copper was added by wet impregnation and the γ -Al 2 O 3 was then calcined at different temperatures to study the effect on the material's properties.

    MORE
  • 2020/09/03· Abstract Cobalt catalysts were prepared by wet impregnation of four distinct supports: alumina, magnesia and two mixed supports of alumina with magnesia (10 and 30 wt%), prepared by wet impregnation of magnesia precursor on alumina. Magnesia addition decreased catalyst acidity and reduced spinel phase formation; however, high magnesia content (30 wt%) decreased catalyst

    MORE
  • The stock solution of salt was made by dissolving magnesium chloride (MgCl 2, Sigma Aldrich, ≥98%) into deionized water.Ammonium hydrogen carbonate (NH 4 HCO 3, Sigma Aldrich, 99%), sodium hydroxide (NaOH, Sigma Aldrich, ≥98%) or ammonia water (NH 4 OH, Merck, 25 wt%) solutions were obtained by dissolving them in deionized water and they were applied as precipitant agent at the

    MORE
  • Effect of Cement and Sol Combined Binders on High-Alumina Refractory Castables Ritwik Sarkar, Jatothu Srinivas, Arabinda Mondal Volume 8, Issue 4, Pages 73 78 Keywords: cement, sol, combined binder, alumina castable

    MORE
  • The formation of nascent alumina and magnesia from nitrate additives at a higher temperature accelerated the spinel formation reaction. When the sintering temperature was increased to 1500 °C the higher density values were observed in additive containing batch due to a greater extent of sintering in the samples.

    MORE
  • Magnesium aluminate spinel (MgAl 2 O 4) has high melting point (2135 C), low coefficient of thermal expansion (10.2 × 10 −6 / C at 1500 C, 8.4 × 10 −6 / C at 1000 C), high mechanical strength, corrosion resistance to acid or alkaline slag, excellent optical and dielectric properties, thus it is widely serviced in refractories, catalyst supports, sensors, etc [1–3].

    MORE
  • The effect of alumina precursors on microstructure, sintering and creep behavior of sol gel derived mullite ceramics was studied by scanning and transmission electron microscopy (SEM, TEM and HRTEM), dilatometry and measuring the creep resistance in 4-point bending mode.

    MORE
  • Abstract The thermal evolution of a sol–gel derived cobalt aluminate (CoAl2O4) of a spinel-type structure was studied. The samples were prepared by the sol–gel technique using aluminum-sec-butoxide [Al(OsBu)3] and cobalt nitrate hexahydrate Co(NO3)2 × 6H2O as starting materials and ethyl-acetoacetate (C6H10O3) as a chelating agent. The powder precursors were annealed at various

    MORE
  • Abstract: Tests were performed to investigate the microstructure of MgAl 2 O 4 spinel layer between magnesia and alumina after high temperature thermal treatment (1500 C and 1600 C). [2] E. Yalamac, C. Carry, S. Akkurt, Microstructural development of interface layers between co-sintered alumina and spinel compacts, J. Eur. Ceram.

    MORE
  • Thermal evo-lution of alumina prepared by the sol-gel technique. Journal of Materials Synthesis and Processing, 6(1), 1-7. Wei Wu, Zhijian Wan, Mingming Zhu, Dongke Zhang. (2016). A facile route to aqueous phase synthesis of

    MORE
  • With the above solution, precursor fibers of magnesia-alumina spinel were prepared by electrospinning technology, which then were calcined at 900 to finally produce fibers of magnesia-alumina spinel. The effect

    MORE
  • J. Am. Ceram. Soc., 88 [11] 3241–3244 (2005) DOI: 10.1111/j.1551-2916.2005.00564.x r 2005 The American Ceramic Society Journal Synthesis of MgAl2O4 Spinel Powder by Combination of Sol–Gel and Precipitation Processes Guotian Ye,w George Oprea, and Tom Troczynski Department of Materials Engineering, University of British Columbia, Vancouver, BC, Canada V6T 1N5 MgAl2O4 spinel precursor

    MORE
  • 2020/09/03· The main objective of this work is to study the effect of magnesium oxide addition as a basic promoter in different contents on Co/Al 2 O 3, in order to reduce alumina acidity and contribute for enhancing catalyst activity and hydrogen production during glycerol steam reforming.

    MORE
  • Alumina and magnesia sources were combined at compositions of 80:20 and 90:10 weight ratio, pressed and reaction sintered at temperatures 1200ºC, 1300ºC, 1400ºC, 1500ºC and 1600ºC. Increase in the spinel content formed, was observed in samples fired at higher temperatures.

    MORE
  • 2003/01/01· Hence, magnesia rich or alumina rich spinel (nonstoichiometric) compositions are important from the application point of view. Spinel formation from its constituent oxides is associated with 5% volume expansion which hinders the densification process to take place in the same firing [2] .

    MORE
  • The effect of spinel grain size and solid content of silica sol on the flow value, sintering, mechanical strength and microstructure of the specimens treated at varying temperature of 400, 1000, 1500, and 1650 C for 5 hours in an air

    MORE
  • Magnesium aluminate (MgAl2O4) spinel produced via self-heat-sustained (SHS) technique Lim Rooi Pinga,1, Abdul-Majeed Azadb,*, Teng Wan Dunga aCeramics Technology Center, SIRIM Berhad, 1 Persiaran Dato' Menteri, Section 2, 40911 Shah Alam,

    MORE
  • 2020/05/16· Alumina-based ceramic cores with MgO addition were prepared using sol–gel process. Prior to magnesia addition, the suitable amount of titania content was determined in the previous research, where it was found that the body with 15 wt% titania had the most suitable properties. The effect of magnesia addition on mechanical, physical, thermal, chemical, and microstructural

    MORE
  • of nanopowder via sol-gel method by magnesium nitrate and oxalic acid as a precursor and investigating the e ect of synthesized MgO powder on the wear property of alumina. 2. Materials and Methods e magnesia (MgO study is 3)

    MORE
  • 2005/08/11· Akhilesh Kumar Singh and Ritwik Sarkar, Development of spinel sol bonded high pure alumina castable composition, Ceramics International, 42, 15, (17410), (2016). Crossref Shiva Salem,Phase formation of nano-sized metal aluminates using divalent cations (Mg, Co and Zn) by autoignition technique,Ceramics International,42,1,(1140),(2016) .

    MORE
  • Abstract The thermal evolution of a sol–gel derived cobalt aluminate (CoAl2O4) of a spinel-type structure was studied. The samples were prepared by the sol–gel technique using aluminum-sec-butoxide [Al(OsBu)3] and cobalt nitrate hexahydrate Co(NO3)2 × 6H2O as starting materials and ethyl-acetoacetate (C6H10O3) as a chelating agent. The powder precursors were annealed at various

    MORE
  • Alumina and magnesia sources were combined at compositions of 80:20 and 90:10 weight ratio, pressed and reaction sintered at temperatures 1200ºC, 1300ºC, 1400ºC, 1500ºC and 1600ºC. Increase in the spinel content formed, was observed in samples fired at higher temperatures.

    MORE
  • Magnesium Aluminate Spinel (MgAl2O4) nanoparticles were synthesized by the co-precipitation method using 2 different precipitants, i.e., urea and ammonium bicarbonate. The precipitated precursor synthesized using urea as a precipitant was a platelet-like hydrotalcite (Mg6Al2CO3(OH)16• 4H2O). The hydrotalcite decomposed to MgO and an amorphous phase after calcining at 600 o C for 2 h. The

    MORE
  • The effect of insitu generated magnesia and alumina from nitrate precursor was also studied. The sintering study was done in the temperature range 1200-16000C.The phase and microstructure was studied with varying milling time

    MORE
  • Thermal evo-lution of alumina prepared by the sol-gel technique. Journal of Materials Synthesis and Processing, 6(1), 1-7. Wei Wu, Zhijian Wan, Mingming Zhu, Dongke Zhang. (2016). A facile route to aqueous phase synthesis of

    MORE
  • In the present research, magnesia nanopowders were synthesized via sol-gel method. In order to investigate the effect of MgO nanopowders on the physical properties of sintered alumina, the alumina specimens with 0.1, 0.3, and 0.5 wt% of MgO were prepared by isostatic press as ball and were sintered at 1570°C for 4 hours under an inert atmosphere.

    MORE
  • Magnesium aluminate (MgAl2O4) spinel produced via self-heat-sustained (SHS) technique Lim Rooi Pinga,1, Abdul-Majeed Azadb,*, Teng Wan Dunga aCeramics Technology Center, SIRIM Berhad, 1 Persiaran Dato' Menteri, Section 2, 40911 Shah Alam,

    MORE
  • Magnesia-alumina spinel/yttrium aluminum garnet composite fibers were prepared by sol-gel method. The spinnability of precursor sol remarkably depended on the addition amount of polyvinylpyrrolidone. Long gel fibers, with 80

    MORE
  • Thermal evo-lution of alumina prepared by the sol-gel technique. Journal of Materials Synthesis and Processing, 6(1), 1-7. Wei Wu, Zhijian Wan, Mingming Zhu, Dongke Zhang. (2016). A facile route to aqueous phase synthesis of

    MORE
  • The effects of different precipitant agents on the formation of alumina-magnesia composite powders as the magnesium aluminate spinel precursor Author links open overlay panel Golara Kafili a Amir Alhaji b Show more Share Cite

    MORE
  • The effect of magnesia-alumina spinel precursor sol on the sintering performance of the fused MgO refractory is investigated. The results show that the sintering of MgO refractory can be promoted with a certain amount of spinel

    MORE
  • The effect of insitu generated magnesia and alumina from nitrate precursor was also studied. The sintering study was done in the temperature range 1200-16000C.The phase and microstructure was studied with varying milling time

    MORE
  • 2005/08/11· Akhilesh Kumar Singh and Ritwik Sarkar, Development of spinel sol bonded high pure alumina castable composition, Ceramics International, 42, 15, (17410), (2016). Crossref Shiva Salem,Phase formation of nano-sized metal aluminates using divalent cations (Mg, Co and Zn) by autoignition technique,Ceramics International,42,1,(1140),(2016) .

    MORE
  • Magnesium aluminate (MA) spinel is synthesized by reaction sintering from alumina and magnesia. The effects of mechanical activation of Al2O3 on reaction sintering were investigated. Non-milled α Al2O3 and α Al2O3 2O3α

    MORE
  • Abstract. A solution for electro-spinning of fibers was prepared via non-hydrolytic sol-gel method with ethanol and dimethyl formamide (DMF) as solvent, MgCl 2 and AlCl 3 as raw material and polyvinylpyrrolidone (PVP) as additive. With the above solution, precursor fibers of magnesia-alumina spinel were prepared by electrospinning technology

    MORE
  • Magnesium−alumina mixed oxide catalysts at Mg:Al atomic ratios of 3:1, 2:1.8, and 1:2.8 were synthesized by using the sol−gel technique. Dehydroxylation and phase transformations were studied with thermogravimetry. Crystalline structures were measured with X-ray powder diffraction. Position and concentration of anionic and cationic vacancies were obtained by refining crystalline structures

    MORE
  • In the monophasic sol-gel synthesis of mullite, alumina and silica are mixed in molecular range and tetragonal mullite always forms at ~980 C [21, 22]. In the diphasic sol-gel synthesis, the homogeneity scales is between 1–100 nm and the orthorhombic mullite forms at 1250 °C [ 23,24 ].

    MORE
  • Ceramics-Silikáty. 62.,(3) 279 284 (2018) Magnesia-alumina spinel/yttrium aluminum garnet composite fibers were prepared by sol-gel method. The spinnability of precursor sol remarkably depended on the addition amount of polyvinylpyrrolidone. Long gel fibers, with 80 cm in length, were obtained by adding 28wt% spinning additive.

    MORE
gotop